Ten Rows High – Three More to Go

by Todd Walker

This is my Field of Dreams. I’ve long dreamed of moving back to the land where I cut my teeth. Each day, each long, hot or cold day on this patch of Georgia dirt brings the dream closer.

Ten Rows High - Three More to Go

This past Memorial Day weekend, a few of the Fuel the Fires crew and family joined in to raise more logs. This kind of work ain’t easy. It’s hard and dangerous at times. But they roll up their sleeves anyway.

This whole log cabin thing is like building a house with a sack of carrots. Nothing is uniform. Logs have big ends and little ends, bows and curves and bends. The goal is to stack them in place so the walls are relatively level.

We started Saturday morning with six and a half rows of logs from our last stacking party in November 2022 (pictured below).

Ten Rows High - Three More to Go

Donny is a smooth operator on the boom truck even with stitches in his shoulder. 

Ten Rows High - Three More to Go

Couldn’t do it without A & W Mechanical and Fabrication’s boom truck. Thank you Wendy and Bryan!

Ten Rows High - Three More to Go

After setting a log, we tack both ends to the log below by driving a stick of 1/2 inch rebar vertically through the top log into the log underneath. This holds the log in place while holes are drilled along the length of the log where more rebar stakes are pounded in to fully secure the log wall. 

As holes are being drilled, we grab and drag the next log with the tractor to be rigged and lifted.

Ten Rows High - Three More to Go

The log-getter crew.


Ten Rows High - Three More to Go

J.J. guiding the next log lift with a tag line.


Ten Rows High - Three More to Go

Blake and Simmons driving rebar.

I wasn’t prepared for the loss of sledge hammer heads. One of the short handled sledge hammers snapped and left me scrambling for tools. Mel took off at lunch break and found two at Ace – 5 and 8 pound hammers. J.J. cut the handles down to accommodate short swings in tight places. 

Ten Rows High - Three More to Go

Eight and a half rows completed on day one.

We worked up an appetite on a long day and finish up with a meal fit for log home builders!

Ten Rows High - Three More to Go

Blake and Co. treated the crew to a low country boil at the end of day one!

By the end of day two, the 10th row was perched 15 feet off the ground in places. I decided the practice of straddling logs to drive metal stakes through logs had to be remedied.

Ten Rows High - Three More to Go

Mel of the Mountains and Tac-Santa getting hammered!

Scaffold System

Over the past five years of research, I’ve come across some great log cabin builds online. One which is similar in size to my build is located in the state of Washington. I adopted his scaffold system as it seemed sturdy and movable as needed. Building with no mortgage, I’m always cutting corners on costs and doing it as safe as possible.

The brackets are easy to build, lightweight, and adjustable. I used scrap 2×4’s, 1×6’s, and other scavenged material from construction dumpsters over the years. I did have to purchase a few 2×10’s for walk boards – which shocked my senses and wallet! 

Ten Rows High - Three More to Go

1/2 inch all thread rod shown at the top of the 2×4 bracket with washer and nut.


Ten Rows High - Three More to Go

The all thread passing through the log with a 2×4 on the outside wall securing the bracket.

Why is the all thread so long for the brackets? Well these all tread pieces were already cut to be used to secure the vertical ridge pole support logs to the wall logs (more on that process once the walls are complete). 

Ten Rows High - Three More to Go

Blocking is used between the bracket and log wall for leveling the scaffold as need.

Shown in the picture above is a piece of 2×4 and 1×4 wedged and screwed to the bracket, not the log, which levels the top of the bracket. Of course you’ll want to do this before walk-boards are on the brackets. You have to be creative when building with a bunch of carrot-shaped logs. 

Ten Rows High - Three More to Go

The first side done with only one walk board and no handrail yet. OSHA would not be happy.


Ten Rows High - Three More to Go

Two sides of scaffold installed with handrails


Ten Rows High - Three More to Go

Scaffolding complete on all four interior walls.

With the scaffolding complete, we’re ready to add the remaining three rows of logs to complete the walls. There may still be log-straddling required to pin these logs, but the scaffolding will offer a stable landing if needed. 

As always, Keep Doing the Stuff of Self-Reliance!

~ Todd

P.S. ā€“ You can also keep up with the Stuff weā€™re Doing on TwitterPinterestYouTubeInstagram, and Facebookā€¦ and over at our Doing the Stuff Network.

P.P.S ā€“ If you havenā€™t done so already, be sure to check out the new Survival Sherpa School and smash that subscribe button at the top of the page!

Thanks for Sharing the Stuff!

Copyright Ā© by Survival Sherpa: Content on this site (unless the work of a third-party) may be shared freely in digital form, in part or whole, for non-commercial use with a link back to this site crediting the author. All links in articles must remain intact as originally posted in order to be republished.

Categories: Log Cabin, Self-reliance | Tags: , , , | 1 Comment

Post navigation

One thought on “Ten Rows High – Three More to Go

  1. Pingback: Log Walls Completed | Survival Sherpa

Leave a comment

Blog at WordPress.com.